SARGENT also offers the 16 function for its 8800 Series and 8900 Series. This function allows the outside trim to be locked from the inside trim. Available as a cylinder or thumbturn on the inside chassis, this function provides a quick way to lock the outside trim without opening the door. The latch will retract when using a key on the outside trim.
SARGENT’s integrated 3287 Door Status Switch provides verification that the door is secure. Available with electrified exit devices, this switch sends a notification to the monitoring system when the door is out of position.
The AL- Alarmed Exit option is designed for areas requiring a standalone alarm on out swinging doors. This option sounds immediately upon exit and discourages unauthorized use.
The 53 Latchbolt Monitor Switch provides true, tamper resistant latchbolt monitoring. The monitor switch is activated when the rail is depressed or for any reason that the latch moves.
Available as an option for its electrified devices, the 54 Latchbolt Monitor sends a signal when the outside lever is rotated for entry.
SARGENT’s 56 Electric Latch Retraction allows electrified retraction of latchbolt for momentary or maintained periods. The device returns to normal operation if fire alarm goes off or if there is an interruption of power to device. Opening remains unsecured while latchbolt is held retracted.
Ceco Door ArmorShield
ASSA ABLOY company Ceco Door Products offers a Level 4 Bullet Resistant door system. These 1-3/4” thick ArmorShield Level 4 doors conform to the Steel Door Institute guide specification, ANSI A250.8 and provide bullet resistance in accordance with UL 752.
Door face sheets are butted with edge seams welded the full height and ground smooth. No seams are visible on faces or vertical edges. Twenty-two gauge steel vertical stiffeners are placed 6” apart and welded every 5” along their length. Inverted top and bottom channels are 16 gauge steel and are welded to both face sheets.
ArmorShield Level 4 frames are double rabbet profile in depths from 4- 5/8” - 12” of all welded construction. Jamb anchors for masonry wall are included.
Hardware Provisions: Hinge preparations are handed. Hinge edges are mortised for 5” high x .190 heavy weight hinges. Seven-gauge steel reinforcements are welded in place and are drilled and tapped for fasteners in accordance with ANSI A156.7. The door lock edge has a standard bevel (1:16) and is prepared for Series 86; lock jamb preparation is for 4-7/8” high strike. Lock is required to be UL listed for ballistic protection. Hardware is not required to be Ceco.
For more information on the complete ASSA ABLOY line, visit www.assaabloydss.com.