Vertical adjustment of the deadbolt keeper or deadlatch ramp allows for alignment with a wide variety of mortise locks with offset latches. It accommodates up to 1” deadbolt (Night-latch function only, bolt will not release). Up to 1/8” horizontal adjustment is possible for misaligned frames.
- Accommodates 3/4” latch projection
- Centerline face plate included for centerline entry
- Heavy duty stainless steel construction
- Plug connectors are furnished for ease of installation and removal during strike servicing
- Tamper-resistant screws included
- Hex and security driver bit included
- Low current draw (0.19 amps @ 24 VDC)
- Unique solenoid design prevents keeper from heating up
- Trim plate included
Wiring Instructions: Use the appropriate wire harness supplied.
12V for 12VDC & 12-24VAC
24 for 24VDC only
Attach the red wire to (+) positive of the power supply. Attach the black wire to the (-) negative of the power supply.
If using AC power, polarity is not observed.
Note: If a suppression diode is required for access control, observe proper polarity.
Latch Monitor Wires:
Black = Common (C)
Blue =NormalClose (NC)
Orange =NormalOpen (NO)
For more information, contact your local locksmith distributor or Schlage, web site http://www.securitytechnologies.ingersollrand.com.
TRINE 4100 Electric Strike
Called “The One Box Solution for Cylindrical and Mortise Locks,” the Trine Access Technology 4100 electric strike contains the four most popular faceplate configurations (covering 90 percent or more of installations without deadbolts). This fire rated 4100 will minimize installing and specifying difficulties of the past.
The Trine 4100 adapts to multiple voltages (12/24 DC and 12-24 AC), features a low profile (1-3/8”) backset and stainless steel trim skirt to allow for maximum flexibility.
The 1 – 3/8” shallow backset allows the #4100 to be used in 2” fire rated frames with 1/2” sheetrock ingress, as well as tight spots in general.
ANSI Grade 1 is met by its 3,250 lbs. holding force and 1,000,000+ life cycles which allow it to be used in the most demanding environments. It is 3 hour Fire Rated WH and soon to be ETL Burglary Rated.
The Trine 4100’s low current draw of .240 Amps at 12DC is ideal for PoE installations. The current draw of .114 Amps at 24DC allow for smaller power supplies in all installations.
Included in the one box solution are additional Torx® security screws and latch shims for compensating horizontal door play.
For more information, contact your local locksmith distributor or Trine, web site www.trineonline.com.
BEA Gate Locks
Designed with a rugged stainless steel housing and conduit fitting, BEA’s electromagnetic locks are suited for indoor or outdoor sliding and swinging gates and high security doors.
The BEA 10GL1200R is the front mount model with conduit connection. The BEA 10GL1200S is the side mount model.
- UL Listed.
- Built-in remote lock status sensor – ideal for remote monitoring
- No residual magnetism
- Field selectable 12 or 24 VDC
- Built-in surge protection
- UL and ULC Listed for use on fire rated doors for up to 1½ hours
- NEMA 4 certified
Input Voltage: 12-24 VDC
Current Draw: 500mA@ 12VDC; 250mA@24VDC
Contact Rating: 0,250A@12 or 24VDC