Wired Vs. Wireless: Access Control Basics

Statistics show that fewer than 10 percent of commercial buildings use electronic access control. Many of those commercial buildings have fewer than 10 doors. This provides a phenomenal opportunity.


Electronic access control has grown dramatically over the last decade. New products and mechanisms make installation easier and new technologies improve levels of security and control.

Many of us seem to forget how new the technology really is and how few systems have been installed. According to a number of resources, less than 10 percent of commercial buildings have electronic access control. A significant number of those commercial buildings have fewer than 10 doors. This provides a phenomenal opportunity.

Wired and wireless are the two basic choices for electronic access control systems. Installing both types of access control mechanisms require understanding of how the systems and components operate, and what equipment is used to build the chosen system.

 

Wired

Since most locksmiths have installed electric strikes, electrified locks and/or magnetic locks as part of single-door remote release or access control systems, we will begin by discussing wired access control systems.

Remote Release. The basic remote release single-door access control system incorporates an electronic locking mechanism such as an electric strike, lock or magnet. The locking mechanism is wired to a power supply that provides the proper voltage and sufficient amperage to power the lock. A momentary switch is installed, typically at a desk or counter having visual access to the opening.

Pressing the button either powers the locking mechanism or removes power from the locking mechanism, permitting the door to be opened. Access is controlled by a person who presses the button. When no one is near the button, remote access is not possible.

Standalone Readers. The next level of single-door access control replaces the person controlling access with credentials and a standalone access control reader. This unit contains the reader, software and the controller platform. These programmable readers determine the number of users, type of credential and functionality. The reader is usually card and/or keypad. Programming is normally accomplished at the reader. An administrator or locksmith can set up and maintain the access control system.

The standalone access control reader is located on the exterior of the swing side of the door. This reader is wired to the locking mechanism and the power supply. Each component of this access control system is electronic and requires power. The power requirements determine the type and size of the power supply.

Unlike the momentary button, the standalone access control reader grants access based on the credential presented. If the credential is valid, access is granted; the lock is unlocked for a predetermined time. If the credential is not valid, access is refused; the lock remains locked.

Multiple Doors. The next level of wired access control is for two or more doors, each having their own access control reader and locking mechanism. A power supply can be shared between doors as long as there is sufficient amperage to power all doors at the same time.

At this level, multiport controller platforms are capable of controlling access, managing alarms and interfacing with an array of reader devices. Many multiport controller platforms are scalable to incorporate up to 64 doors using dual sub controller card reader interface panels for additional openings. Single sub controller card reader interface panels are available for odd numbers of doors.

These panels are available from access management companies, software providers, card access control systems manufacturers and locksmith distributors to control access. The panels must be configured to the software to operate with the users, the locks and the reader devices. Functionality of the locks is determined by these companies.

Once the panels have been configured, they are installed along with the chosen access control hardware. After they have been wired, the access control software is set -up and programmed to the doors, readers and locks. Then the users are programmed as individuals or in groups. An administrator or locksmith can manage the access control system.

This content continues onto the next page...

We Recommend